Behringer VIRTUALIZER 3D FX2000

Hookin up those Audio Boxes without gettin yourself Perplexed.
Post Reply
IT9PQJ
Voodoo Audio Head
Posts: 12
Joined: Sat Jan 04, 2014 4:03 am

Behringer VIRTUALIZER 3D FX2000

Post by IT9PQJ »

I've thought to add the FX2000 with preset # 62 ULTRBASS but have to figure out where exactly... Like last piece (after the DSP2024), before the DSP2024, or between DEQ2496 and EX3200... ???
I'd also appreciate some nice settings for the preset #62.

My current setup:
Behringer T-1 microphone
MIC2200
DEQ2496 (with PEQ, DEQ and DYN on)
EX3200
MDX2600
DSP2024 (sometimes on PLAT, sometimes on STUD)

73,
Nico
Last edited by IT9PQJ on Sat Jan 11, 2014 5:59 pm, edited 1 time in total.

IT9PQJ
Voodoo Audio Head
Posts: 12
Joined: Sat Jan 04, 2014 4:03 am

Post by IT9PQJ »

Hi you all!
Hope this will be useful to someone.
Work is in progress, but I've done the following up until now...

My usual setup:
Behringer T-1 microphone
MIC2200
DEQ2496 (with PEQ, DEQ and DYN on) --> I'd like to find out more on this DYN staff, so any suggestion is welcome, although I believe I'll find out on my own soon!
EX3200
MDX2600
DSP2024

...At the moment the FX2000 is between the compressor MDX2600 and the other effect processor DSP2024 (this one uses PLAT or STUD effects found on this forum). It already does its job but I want to try put it in a couple of other combinations in order to see any difference in audio processing.
I've modified its preset #62 U.BAS original settings... I'll try to post them later if required.
73,
Nico

User avatar
Voodoo Guru
VooDoo Site Admin
Posts: 719
Joined: Wed Feb 23, 2005 8:47 am
Location: Down there on the right...

Post by Voodoo Guru »

Howdy Nico,
It sounds like your up to some great experimenting over there.
This is what it takes, trying things out until you find the combination that sounds the best to you.
Curious to see how your final setup works for you.
Take Care,
Voodoo Guru
From Deep in the IDD of the Sub-Harmonix Realm

IT9PQJ
Voodoo Audio Head
Posts: 12
Joined: Sat Jan 04, 2014 4:03 am

Post by IT9PQJ »

Hi Guru!
Thanks for your interest!
Combination is as the following and that's the only one I've tried so far since as it seems to be working fine:

MIC2200

DEQ2496

EX3200

MDX2600

FX2000

DSP2024

I wish we could meet on the air someday. I'm active most of the time on 10m (from around 28.350 to 28.500... 28.730 is too high for me since as my ANT is almost a dummy load up there... Looking forward to modify it so that I can use the whole 10m range).
Best regards,
Nico

Post Reply