Hi,
I have just bought a triple C to install after my EX3200 and before my DSP2024. It looks like I need balanced TRS leads but I am not sure. Can anybody confirm the leads and which input and outputs are used and if the channels are tied together.
73's Glenn M1 AQO
Triple C installation
- Voodoo Guru
- VooDoo Site Admin
- Posts: 719
- Joined: Wed Feb 23, 2005 8:47 am
- Location: Down there on the right...
Howdy Glenn,
The Triple C uses 1/4" TRS Balanced Connectors.
The Triple C came in 2 flavors, the Single Channel Version and the Stereo Version. It will be labeled as such on the front panel.
The Single Channel version looks like it has 2 inputs and outputs for 2 channels, but 2 of the jacks are for side chaining. The jacks are clearly marked as to their function.
On the Stereo Unit, usually only one channel is used on the Triple C and the 2 channels are not tied together.
Take Care,
The Triple C uses 1/4" TRS Balanced Connectors.
The Triple C came in 2 flavors, the Single Channel Version and the Stereo Version. It will be labeled as such on the front panel.
The Single Channel version looks like it has 2 inputs and outputs for 2 channels, but 2 of the jacks are for side chaining. The jacks are clearly marked as to their function.
On the Stereo Unit, usually only one channel is used on the Triple C and the 2 channels are not tied together.
Take Care,
Voodoo Guru
From Deep in the IDD of the Sub-Harmonix Realm
From Deep in the IDD of the Sub-Harmonix Realm