Page 1 of 1

help me please/just setting up.

Posted: Fri Sep 03, 2010 5:45 pm
by daz/zdz
hi voodoo guys.

i hope you can help me.... iv been off the radio for 15 years and came

back on not long ago.....since then iv herd a few radio armatures
on 20 meters chatting about voodoo audio.... since then iv looked
on your voodoo site as i am very interested in setting up some
audio for ssb... since then iv bout some audio gear which is
behringer the list is.




I have a euro rack ub1204 FX-PRO MIXER

ART/PROFFESIONAL TUBE MIC PREAMP.

Vertuallizer-PRO DSP 2024-P

MDX-2600.

ultra FEX-PRO-/EX3200


what i need to know is what order do they all go in too get the
best audio from the system and from the equipment that i have have got
that is listed in this e-mail and also has anybody got some
settings that sound really good ...many many many thanks from darrell ....

PS..can you allso tell me what cables go into the units and were do they go . it is a bit of a headach not knowing what order the cabiles go in one unit to the other
hope you can help me to get the best sound from my setup..

many many many thanks i hope to put some of that low end audio on radio amateur bands hope to speak to you soon when i get everything set up here in south yourshire uk .......


The radio i am useing at the moment is the IC756 only NOT THE PRO SERIES untill i get my self an 870 or 950 SDX i will be useing a heil studio mic GM4 with the narrow and the wide swich on the microphone with all the audio gear that i have got ..

PS CAN ANYBODY DRAW ME A DIAGRAM OF EACH UNIT SHOWING ME HOW THE CABLES ARE CONNECTED TO THE UNITS I HAVE GOT HERE .


Posted: Sat Sep 04, 2010 12:47 am
by YO3IBW
I've been off air for about 10 years also. Almost two years ago the radioamateur virus came back stronger and more powerful then ever, with a kind of voodoo accent. :twisted:
About the new toys, congrats. They will sound great!
From my point of view, I would connect them like this,

Microphone Heil GM4
Preamp ART/PROFFESIONAL
Ch1 Behringer MDX2600 - Noise Gate & small compression 4:1
Behringer EX3200 - Spectral Enhancer
EQ - Buy a DSP1024p or a DEQ2496 (the eq is a must! )
Ch2 Behringer MDX2600 - Powerful compression a ratio about 8:1 or bigger.
Behringer DSP2024p - Effects Processor using a small Plating Effect
DIY "iBox" or the version of W2IHY
Transceiver - Icom IC756

I don't know what can you do with the mixer, you've got the ART/PROFFESIONAL mike preamp and I don't know if you need/got everything else to mix. Also there is a risk of RFI interference in every device you connect.

More info about the settings you can find on this forum or on other websites. I would recommend to take a look also on NU9N page.
Good luck and c ya on teh bands! :D

Posted: Sun Sep 05, 2010 5:01 pm
by Voodoo Guru
Welcome to the Forum daz/zdz!!
Glad to have you here.

We really can't add much more to what YO3IBW said,
Even to the mentioning of NU9N's website...
Good show!!! Thanks!