hello to all. i just got an FT-950 rig. i install all the audio chain and really sounding good (acording to reports). i feeding the audio thru the front mike jack. my question is ..do any one could tell me if i could feed the mike audio thru one of the back connectors? (i been checking the book ,but no luck finding) and is if safe to feed it thru the front?
thanks kp2bh/ jimmy
Unfortunately, We haven't had an FT-950 here at the LABS to answer your question about feeding it in the back.
It should be just fine feeding the audio thru the front as long as you do it correctly. If you are trying to input Line Level Audio from your rack equipment directly into your Front Microphone Jack on the rig, then you run the risk of distortion and no control. You will need to bring the Line Level Rack Audio down to Mic Level Audio to input it into the Microphone jack. The attenuator controls on the rack equipment just can't do it well enough and you do not have enough control.
Check out John's site at http://www.nu9n.com/tx.html
Scroll down and you will see how to connect your rack to your transmitter. He gives various solutions to the problem.
Take care,
Voodoo Guru
From Deep in the IDD of the Sub-Harmonix Realm
Thanks for the reply , i just connect the audio rack and iam in the process of adjustments..its sounds good acording to reports from other stations.take care and keep vooodoing. 73's
jimmy/kp2bh
hello to all. i just got an FT-950 rig. i install all the audio chain and really sounding good (acording to reports). i feeding the audio thru the front mike jack. my question is ..do any one could tell me if i could feed the mike audio thru one of the back connectors? (i been checking the book ,but no luck finding) and is if safe to feed it thru the front?