can the ft-450at be use for this tipe of setup,and hi every one new to this want to get in to it.
this is what i have for now xynix 1202fx preamp mixer,mic c01 samson studio condencer,dsp1124p eq,dbx 266xl compressor,radio ft-450.
ft-450at
- Voodoo Guru
- VooDoo Site Admin
- Posts: 719
- Joined: Wed Feb 23, 2005 8:47 am
- Location: Down there on the right...
-
- Audio Head
- Posts: 7
- Joined: Wed Dec 30, 2009 7:15 pm
ft-450at
ok thank you so 2.7kc is not bad but the higher the better, so far its sound good so what type of radio do i need to get the most out of it.and thank you for your help.
-
- Audio Head
- Posts: 7
- Joined: Wed Dec 30, 2009 7:15 pm
ft-450
i have a ft-450 yaesu and i wonder if this radio can be set for voodo audio it does have a secret menu but dont have any idea on ajustments.
I would be very hard-pressed to believe the FT-450 will allow for VooDoo type audio. Even it's big brother (FT-950) isn't capable of such a task. With the exception of the FT-2000 and 9000 (with their extended low frequency reaponse to 50Hz) it's not really going to happen with the '450. At 2.7Khz bandwidth you're audio will sound too "dark", muddy and lack "air" thus receiving reports of, "you're too bassy!!" assuming its capable of the lowend response.
Does the '450 have an audio monitor??--doubt it does at that price point, not to mention it's a mobile radio (which are usually designed NOT to have an built-in monitor). If that's the case a GOOD/RELIABLE secondary receiver is a must.
Does the '450 have an audio monitor??--doubt it does at that price point, not to mention it's a mobile radio (which are usually designed NOT to have an built-in monitor). If that's the case a GOOD/RELIABLE secondary receiver is a must.
-
- Audio Head
- Posts: 7
- Joined: Wed Dec 30, 2009 7:15 pm
ft-450
ok thanks thats what i want to know,im looking to buy the ts-2000.i want to get in to the voodoooooooooooo
ok i think a made my ft-450 reach the 3.0khz using the xynix 1202fx-samson D-2500 eq-dbx 266xl compressor,a friend of mine have the ft-2000 with the monitor system and he said i was in the 2.9khz to 3.0 khz so would that put me on the zone..........of essb or not quite 73s kb3mub.
ok i think a made my ft-450 reach the 3.0khz using the xynix 1202fx-samson D-2500 eq-dbx 266xl compressor,a friend of mine have the ft-2000 with the monitor system and he said i was in the 2.9khz to 3.0 khz so would that put me on the zone..........of essb or not quite 73s kb3mub.
-
- Audio Head
- Posts: 7
- Joined: Wed Dec 30, 2009 7:15 pm