I was wondering: is there an easy way to monitor your signal on a scope?
Found a web site: http://www.cleanrf.com/
Could one of these parts be of any use or is there an easier/cheaper way?
How to scope your signal
How to scope your signal
===================
>> Livin' la VooDoo Loca <<
===================
>> Livin' la VooDoo Loca <<
===================
Scoping your signal
Seen a video on "You Tube" instead of using rf sniffers,he just wrapped a piece of stranded wire around the coax then to the input of the scope.
Mike KC7OV
There was a design which was readily available online years ago--may have been from Tyler's site too. It was rather simple to make, so long as you had the necessary parts on hand it would take about 30 minutes to construct. [If I did it, ANYONE can do it ] And it worked perfectly even with the ole-ass oscilloscope I had at the time.
You can also check out Alan's [W2AEW] video on Youtube.
Nice video's, very helpful, tnx for the link.
Ordered a WaveNode this week.
http://www.wavenode.com/wn-2d.htm
Read good reviews.
Oscilloscope and Spectrum Analysis of the RF Modulation - Observe intermodulation and "Splatter" frequency components real-time: on your computer screen.
Ordered a WaveNode this week.
http://www.wavenode.com/wn-2d.htm
Read good reviews.
Oscilloscope and Spectrum Analysis of the RF Modulation - Observe intermodulation and "Splatter" frequency components real-time: on your computer screen.
===================
>> Livin' la VooDoo Loca <<
===================
>> Livin' la VooDoo Loca <<
===================