Page 1 of 1

Posted: Sat May 11, 2013 11:54 pm
by ECC82
Most Bellari equipment have two channels. When applying the mods is it sufficient (if you use only one channel) to change just the one tube in the channel that you use?

Posted: Sun May 12, 2013 3:40 am
by Voodoo Guru
Howdy,
Most Bellari equipment have two channels. When applying the mods is it sufficient (if you use only one channel) to change just the one tube in the channel that you use?
Sure! That would be just fine. In fact, doing that will save the life of the precious tube that would be just sitting there not doing anything except accumulating hours.

In the future, when you decide to implement that unused channel into the Audio Mix, you can always change the tube to something more suitable.

Take Care,