Having read so much about the EX3200 here on the forum, it is no longer available by Behringer.
Can someone point me in the direction of how to acquire myself one, preferrebly one with the VOOOODOOO Mod. Also, is there a replacement for the EX3200, and if so, how does it compares to the EX3200?
EX3200 or what?
Re: EX3200 or what?
EBAYINXS wrote:Having read so much about the EX3200 here on the forum, it is no longer available by Behringer.
Can someone point me in the direction of how to acquire myself one, preferrebly one with the VOOOODOOO Mod. Also, is there a replacement for the EX3200, and if so, how does it compares to the EX3200?
Or find another ESSB guy parting with his
Bow
Quite possibilly the only 3.3 Khz wide Icom IC-718 in the world...
Quite possibilly the only 3.3 Khz wide Icom IC-718 in the world...
- Voodoo Guru
- VooDoo Site Admin
- Posts: 719
- Joined: Wed Feb 23, 2005 8:47 am
- Location: Down there on the right...
- YO3IBW
- VooDoo Audio Crew
- Posts: 40
- Joined: Sat Aug 08, 2009 8:14 am
- Location: Bucharest, Romania
- Contact:
There where a discussion on this forum about BEHRINGER SX3040 that this could be the new version of EX3200. Anyone did any test on this new box?
73 de Dan YO3IBW
http://www.buz.ro
http://www.buz.ro
I think I would hold off on purchasing a EX3200 right now,... the HFA04TB60PBF-ND HexFreds seem to be very hard to find. The backorder dates for them are over a year (5/2011) was what I was quoted today.
VooDoo Guru, can you recommend a substitute part or another value that would be acceptable to replace the HFA04TB60PBF-ND with?
Thanks.
XLAXX
VooDoo Guru, can you recommend a substitute part or another value that would be acceptable to replace the HFA04TB60PBF-ND with?
Thanks.
XLAXX
... da Voodoo cometh and my cup runneth over...
Did the mod after ordering the Hex Freds from Farnell. The difference in the low end is truly amazing. I was very surprised.
My only problem at this point is fiddling with the higher end. I still can hear some distortion in my 'SSS' and 'TTTs' .
Any parameters I can re-adjust in the DEQ-2496 to help me out with this?
Thanks
XLAXX
Did the mod after ordering the Hex Freds from Farnell. The difference in the low end is truly amazing. I was very surprised.
My only problem at this point is fiddling with the higher end. I still can hear some distortion in my 'SSS' and 'TTTs' .
Any parameters I can re-adjust in the DEQ-2496 to help me out with this?
Thanks
XLAXX
- Voodoo Guru
- VooDoo Site Admin
- Posts: 719
- Joined: Wed Feb 23, 2005 8:47 am
- Location: Down there on the right...
Howdy XLAXX,
Check out the post in this thread -
http://www.wz5q.net/talkvoodoo/viewtopic.php?t=316
Take Care,
Check out the post in this thread -
http://www.wz5q.net/talkvoodoo/viewtopic.php?t=316
Take Care,
Voodoo Guru
From Deep in the IDD of the Sub-Harmonix Realm
From Deep in the IDD of the Sub-Harmonix Realm