triple c firmware update. error codes

How to take the Trouble out of Shooting your problematic Voodoo Audio.
Post Reply
User avatar
w5kai
Voodoo Audio Head
Posts: 33
Joined: Sat Mar 19, 2011 7:33 pm
Location: Salty Swamps of Mississippi

triple c firmware update. error codes

Post by w5kai » Mon Oct 15, 2012 3:16 pm

Hello Gang,
Needing some help here with the triple c firmware.
I'm try'n to do the v2.02 and I keep getting error code 6. Looking at the instructions it says reboot after error code 9 or 1 and try again. Well I'm getting the triple c to start downloading the new verison 000 to 0037 then it stops and shows this error code 6 . I've rebooted and started over many times and it always stops at 037 then the error code 6? I haven't been able to even find error code 6 on the internet and have had no luck with contacting tc electronics. Any input will help. THX w5kai
VMSDX # 24
Special Zombie Edition

User avatar
Voodoo Guru
VooDoo Site Admin
Posts: 718
Joined: Wed Feb 23, 2005 8:47 am
Location: Down there on the right...

Post by Voodoo Guru » Mon Oct 15, 2012 6:26 pm

Howdy Steve,

We have had the same problem and found out it was the USB interface. The Triple C didn't like the USB running with Windows 7 64. We had to wind up using Windows XP and using the Game controller to MIDI cable in the Audigy Soundgcard.

You might have to try some different configurations and or Operating systems.

Good Luck
Voodoo Guru
From Deep in the IDD of the Sub-Harmonix Realm

Post Reply